Maytag MRT311FFFZ Mode D'emploi page 7

Reverse Doors (optional)
See complete graphics later in these instructions.
Door Hinge Cabinet Hinge
Hole Plug Hole Plug
Dome Cap Dome Cap
Washer
Shoulder
Screw Washer
Reverse Center Hinge
1. Remove the three dome caps and screws from the handle
side and use them to fill the holes created when the hinge
screws were removed.
A
B
C
A. Dome cap washers
⁵⁄₁₆
B. " hex-head hinge screws
C. Dome caps
2. Using the three ⁵⁄₁₆" hex-head hinge screws removed in
Step 1, insert two screws halfway into the holes, leaving
space to insert the center hinge.
3. Slide the center hinge (from the right) onto the screws, insert
the third screw, and then tighten all screws completely.
NOTE: Make sure the washers are in place on both the top
and bottom pins of the center hinge.
A
⁵⁄₁₆
A. " hex-head hinge screws
B. Washers
Setscrew Door Stop
Screw
Shoulder Flat-Head
Screw Handle
Screw
Door Handle
Hole Plug
B
Reverse Freezer Door
1. Remove the three cabinet hole plugs from the top of the
cabinet and place them in the hinge holes on the opposite
side.
A
2. Remove the door stop from the bottom of the freezer door.
3. Move the door stop to the opposite side, making sure that the
hole in the door stop plate is aligned perfectly with the hole for
the center hinge pin.
4. Using the screw removed in Step 2, fasten the door stop to
the bottom of the freezer door.
Reverse Refrigerator Door
1. Remove door hinge hole plug from refrigerator door. Move
to opposite side hinge hole.
2. Remove the door stop from the bottom of the refrigerator
door.
A
A. Cabinet hole plugs
A B
A. Door stop screw
B. Door stop
A. Door stop screw
A B
A. Door stop screw
B. Door stop
A
7