EUROM RAD 2000 Oil free Manuel D'utilisation page 28

Installation, location and connection
•
Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact your
vendor for inspection or replacement.
•
Turn the radiator upside-down (make sure you don't scratch the paint or the floor!)
•
Screw the two supports (each with 2 swivel castors) firmly to the radiator, see picture.
•
Return the heater to its upright position, wheels down.
•
Select a suitable location for the device taking into account all the aforementioned
warnings in this manual.
Warning: only use the heater when it is in an upright position, with the wheels attached to
the bottom (as pictured on the front of this booklet). Any other position is dangerous!
Set-up and operation
•
Make sure that both power buttons are set to off (not pressed in) and turn the
thermostat knob as far as possible towards Max.
•
Now insert the plug into the socket.
•
Operate the heater by pressing one or both power buttons: 1
button pressed = 1000 W, both buttons pressed = 2000 W.
The heater will start working. To heat up slowly, for a slight
temperature increase or in a small space, press one button
(1000 W). To heat up quickly, for a larger temperature
increase or in a larger space, press both buttons (2000 W).
•
Once the space has reached the right temperature, turn the
thermostat dial to Min until you hear a click. The light goes
out and the heater shuts down. If you leave the dial in this
position, the heater will maintain the current temperature by
regularly switching on and off. When the heater is switched
on, the light will go on. By turning the thermostat dial to the
left/right, you decrease/increase the set temperature.
•
If so desired, you can now switch to a lower power level.
•
To switch off, press the depressed power button(s) again. The
button(s) will come up again. The heater switches off. Unplug.
•
Note! It takes some time for a radiator to cool down. Give the radiator sufficient time
to cool down before touching or moving (use handle!).
28