Publicité
14
PANEL INFORMATION
1 POWER Switch
2 POWER/PROTECTOR
Indicator
When the POWER
switch is turned on and power supplied to the unit,
the Indicator will flash on and off, In several seconds, the {Indicator will
stay lit, indicating the unit is ready to operate to its full capacity. Also,
whenever the protection circuit in the unit is activated, the Indicator
will flash to notify you of an abnormal condition inside the unit. When
you notice this, shut off the POWER switch immediately and eliminate
the cause {such as a short-circuit of the speaker terminals), then turn
the POWER switch on again.
3 SPEAKERS Switch
The SPEAKERS switch selects the speaker system(s) you want to hear.
OFF:
To
cut
off the
source
from
the speaker systems when
listening with headphones.
A:
To drive the speaker systems
connected
to the rear-panel
SPEAKERS SYSTEM-A terminals.
B:
To drive those connected to the SYSTEM-B terminals.
A+B:
Todrive both A and B pairs of speaker systems.
@
When connected speaker systems have rated impedance of
4 ohms or less, do not turn the SPEAKERS switch to the
A+B
position.
Publicité
