Using The Appliance For The Fi Rst Time - Medion MD 16480 Mode D'emploi

6. Using the appliance for the fi rst time
1. Set the control knob to "0" and press the tilt lever to raise the tilting arm.
2. Place the mixing bowl on the fixing tongues in the base and rotate it as far as it will go in the direction
indicated by the LOCK arrow to lock it in place.
DANGER!
Risk of injury by rotating and moving parts
Before changing accessories or attachments that move when in
operation, the appliance must be switched off and disconnected from the supply. There is a
risk of a crushing injury!
3. Fit the splash guard onto one of the three mixing tools (dough hook, beater, whisk), then fit the tool to the
machine as illustrated.
The mixing tools can only be inserted in the machine and rotated if the projections are seated in the
corresponding indentations.
The guard disc prevents the drive shaft from coming into contact with dough.
4. The splash guard for the mixing bowl is ready to fit and can simply be placed over the bowl after it has
been locked in place:
5. Press the tilt lever and lower the tilting arm. Make sure that it is latched home on the bottom part of the
housing. Reconnect the appliance to the mains supply and switch on at the wall socket.
6. The control knob can now be set for the required speed. The recommended speed settings for various
uses are listed below.
• Use the dough hook at speed 1, 2 or 3 for heavy doughs like bread, shortcrust pastry or pasta.
• You can use the beater for many ingredients ranging from medium-weight doughs, such as cake mixes,
to lighter mixtures, such as pancake batter and sponge mix. Use the beater at speed 4, 5, 6, 7 or 8 as
required.
• If you are whipping cream, egg white or blancmange, use the whisk at high speed (7 or 8).
• For short, powerful and continuous pulse movements, turn the control knob repeatedly to the "P"
position.
• The mincer can be used to make various dough products such as noodles and biscuits, to produce
kebabs, to mince meat or to fi ll sausages. The required speed setting is 6, 7 or 8.
7. After the test run, turn the control knob to "0".
8. Press the tilt lever and lift the tilting arm, then remove the mixing tool from the bayonet fitting. Return the
tilting arm to its lowered position.
9. Switch off at the wall socket and unplug.
DE
FR
EN
NL
55 of 86