EUROM 334180 Manuel D'utilisation page 24

Permanent mounting
The Q-Time 1500 is designed for installation in a permanent position and direct
connection to the electricity network. For safety reasons, this installation should be
fitted by an approved electrician.
Plug connection
The Q-Time 1500 can also be connected directly to a power socket using the electric
cable and plug. Make sure that the electric cable does not hang over any (sharp)
edges, does not make any sharp angles, cannot be dragged and does not touch any
hot surfaces.
Important: the electric cable and plug form a whole. Therefore, if either the electric
cable or plug is damaged they should both be replaced by an electrician. Only mount
the original parts!

When positioning and connecting the heater, make sure that your hands do not
touch the heating elements. This is because traces can be left behind which,
afterwards, will have a negative effect on the radiated heat.

For use with a plug, the following applies: do not use extension leads and do not
connect any other equipment next to the heater in the same socket!

Position the mounting bracket with the long side and 2 holes against the wall in
the required position, then mark the drill holes. Make sure that the drill holes are
positioned at the same height! Remove the bracket and drill 2 holes in the spots
marked. Knock in the raw plugs, position the bracket over the top and screw it
firmly into the wall using the screws supplied.

Place the heater over the bracket with the cord down and large holes positioned
over large holes. Screw securely using the bolts, rings and nuts supplied (1).

Turn the heater to the required position. The body of the heater can be turned to
5 positions (small heater holes (3) over
small bracket holes (2)). The mid
position is horizontal to the room. The
two positions which are directed
upwards will only be used in exceptional
cases and require a greater distance to
the ceiling (2 metre). Finally, the heater
has two positions which are directed
downwards. These are the standard
positions. Secure the heater at the
required angle by screwing both of the
small screws into the double holes.

The heater is now ready for use.
The Q-Time 1500 is supplied with a turn-knob with ring and spring washer. This
allows the Q-time to be fitted on an appropriate stand. Only choose a firm stand
and ensure that the stand is stable on a perfectly flat and level surface! The draw-
24