WORKING WITH
DETERGENTS
Detergents can only be applied at low
pressure.
STEP 1:
Install the Vario Power Spray Wand.
Set the spray wand to the low pres-
sure setting (Mix).
OR
Install the Wash Brush.
STEP 2:
Fill a container with Kärcher deter-
gent. Place the filter end of detergent
siphon tube into the container.
STEP 3:
Turn on the pressure washer (I). Pull
trigger to operate unit. Liquid deter-
gent is drawn into the unit and mixed
with water. Apply detergent to work
area. Do not allow detergent to dry
on surface.
STEP 4:
To rinse, move the VPS out of "Mix"
position and pull trigger to operate
unit.
STEP 5:
Cleaning up: Always draw fresh wa-
ter through the detergent tank or si-
phon tube when done to flush any
remaining detergents from the injec-
tion system.
For best results see Cleaning Tips for
specific information on how to clean
different surfaces.
Always Use Kärcher
Best Results
Kärcher
®
biodegradable detergents are
specially formulated to protect the envi-
ronment and your pressure washer. The
special formula won't clog the suction
tube filter and will protect the internal
parts of the pressure washer for a longer
life. For Kärcher
®
your retailer or visit our website:
www.buykarcher.com
CAUTION
Never use:
Bleach, chlorine products and other
–
corrosive chemicals
Liquids containing solvents (i.e.,
–
paint thinners, gasoline, oils)
Tri-sodium phosphate products
–
Ammonia products
–
Acid-based products
–
These chemicals will harm the unit and
will damage the surface being cleaned.
Use of these items will void the war-
ranty.
®
Detergent for
detergents, check
English 9