Beta Motorcycles RR 200 2T EUROPA Mode D'emploi page 144

4
1
EN
REPLACEMENT
Keep the vehicle in vertical position relative
to the ground.
Replacement of the coolant must take place
when the engine is cold.
- Unscrew cap 1.
- Place a container under screw 2.
- Unscrew the screw 2.
- Drain the liquid.
- Tighten screw 2 applying the specific
washer.
2
- Unscrew drain screw 3.
3
- Proceed to filling.
When filling is completed, purge the
engine group through the screw 4. After
purging, verify the liquid level and top up
if necessary.
When filling is completed, purge the
motor group through the screw 4. After
4
purging, verify the liquid level and top up
if necessary.
- Reapply the loading cap and the bleed-
ing screw.
The amounts of liquid are shown on page
16.
54