Beta Motorcycles RR 200 2T EUROPA Mode D'emploi page 142

4
EN
1
15Nm
1
REPLACEMENT
Always perform the replacement when
engine is hot:
- Position the drive on a flat base ensuring
stability.
- Remove the engine casing by loosening
the screws shown in the figure.
- Place a container under the engine.
WARNING:
Hot oil can cause severe burns!
Screw on filler cap 1 again.
- Unscrew filler plug 1 and drain plug 2.
- Drain all the oil from the crankcase.
- Place the cap 2 and tighten to specified
torque.
Pour in the quantity of liquid indicated on
2
page 10.
Use the oil indicated on page 16 in
the "Recommended lubricants and liquids"
table.
WARNING:
Dispose of used oil in compliance with the
regulations in force.
Screw on filler cap 1 again.
WARNING:
Dispose of used oil in compliance with the
regulations in force.
52