Publicité
2-2. Installing And Aligning Wire Guide And Drive Roll
Tools Needed:
3/16 in
3/8 in
OM-1546 Page 10
5
3
6
When changing wire size or type,
check drive roll and wire guide size
(see Parts List).
Installing Wire Guide And Drive
Rolls:
1
2
Turn nut one click until lobes of nut
line up with lobes of drive roll carrier.
3
Slide drive roll onto drive roll carrier.
Turn nut one click.
Repeat procedure for top drive roll.
4
5
Loosen screw. Install inlet guide so
screw is centered in groove in
guide, or so tip is as close to drive
rolls as possible without touching.
Tighten screw.
Aligning Wire Guide And Drive
Rolls:
6
Only top drive roll alignment is ad-
justable. Turn adjustment screw in
or out until groove in drive roll lines
up with wire guide as shown.
Cleaning Drive Rolls:
Remove drive rolls, and clean
grooves using a wire brush.
5
4
2
1
3
Ref. ST-091 547-D / Ref. ST-112 370-C / S-0856
Drive Roll Nut
Drive Roll Carrier
Drive Roll
Inlet Wire Guide Screw
Inlet Wire Guide
Adjustment Screw
Publicité
