Hürner WeldControl EF 250 Manuel Utilisateur page 37

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
3.2 Control Panel
3.3 Connectors
Movement Pushbutton on Machine Chassis
This pushbutton, which allows moving the carriage of the machine,
facilitates welding when the hydraulic and control unit is not located
next to the basic machine chassis. The pushbutton enables the welder,
without leaving the chassis during the welding process, to confirm
various states (e.g., end of butt facing, pipe alignment/offset check,
bead build-up, heating element insertion) that otherwise would have
to be confirmed by pressing the START/SET key on the control unit.
Version January 2018 HÜRNER WeldControl EF 250 User's Manual
Welding Process Diagram
Pressure Release Valve
Display Screen
Maximum Pressure Regulator
MENU and Cursor Keys
Alphanumeric Keypad
Oil Refill Nipple with Level Probe
START/SET and
STOP/RESET Keys
Carriage Mover Lever
Facing Tool Connector
Scanner Connector
Bar Code Scanner
Hydraulic Connectors
Welding Connector
(Heating Element or
Welding Cable)
RFID Transponder
Reader
9
EN