Cristec YPOWER 24V-12V/60A Manuel Utilisateur page 29

Main precaution
Before handling the charger, please read carefully this
manual.
Precautions regarding electric shocks
Risk of electric shock and danger of death: it's strictly
forbidden to interfere with the charger when under
voltage.
Precautions regarding overheating of the appliance
This appliance is designed to be mounted on a vertical
wall or partition as indicated herein.
It is imperative that there be a gap of 150mm around the
charger. The installer must ensure that the temperature
of the air at the input is lower than 65°C in extreme
operating conditions.
Measures should also be taken to allow for the evacuation
of hot air on either side of the charger.
It's strictly forbidden to put any device on or against the
charger.
The charger must not be installed near a heat source; it
should be installed in a well-ventilated area. The charger's
air inlets and outlets must not be obstructed.
Attention hot surface: do not touch the charger
during and after its operation (burn hazard).
28