Motorola L602M Guide De L'utilisateur page 17

3.15 Setting the dial mode
The default dialing mode is suitable for your country and network operator. It is unlikely that
you should need to change this setting unless advised to do so.
1. Press MENU and then VOL+ or REDIAL/VOL- to select
2. Press MENU to select
3. Press MENU and then VOL+ or REDIAL/VOL- to select
4. Press MENU to save.
NOTE
If the pulse mode is selected, press */TONE to switch from pulse to tone dialing temporarily
when dialing out. After the call is ended, the dial mode will change back to pulse.
3.16 Setting the flash time
The default flash time is 600MS. It is unlikely that you should need to change this setting unless
advised to do so.
1. Press MENU and then VOL+ or REDIAL/VOL- to select
2. Press MENU and then VOL+ or REDIAL/VOL- to select
3. Press MENU and then VOL+ or REDIAL/VOL- to the flash time you want.
(8 options are available : 90, 100, 110, 250, 300, 400,
4. Press MENU to save.
3.17 Setting the area code
1. Press MENU and then VOL+ or REDIAL/VOL- to select
2. Press MENU and then VOL+ or REDIAL/VOL- to select
3. Press MENU and then enter the area code.
4. Press MENU to save.
3.18 Registration
3.18.1 Registering a handset
Up to 5 handsets can be registered to one base. The original handset is pre-registered to
use. Additional handsets must be registered to the base before you can use them.
To register an additional handset,
1. Press MENU and then VOL+ or REDIAL/VOL- to select
2. Press MENU and then VOL+ or REDIAL/VOL- to select REGISTRATION.
3. Press MENU and then VOL+ or REDIAL/VOL- to select
4. Select YES then press MENU to enter the registration procedure as follows:
1. Press and hold FIND for around 4 seconds on the base.
2. Place the unregistered cordless handset on the base or charger.
Using the phone
DIAL MODE.
SETUP BS.
TONE or PULSE.
SETUP BS.
FLASH TIME.
600 and 700MS)
SETUP BS.
AREA CODE.
SETUP HS.
YES or NO.
17