Napoleon WMFE1 Instructions D'installation Et D'utilisation page 18

18
9.0 TROUBLESHOOTING
TURN OFF THE APPLIANCE COMPLETELY AND LET IT COOL BEFORE SERVICING. ONLY A
QUALIFIED SERVICE PERSON SHOULD SERVICE OR REPAIR THE APPLIANCE.
SYMPTOM
Smoke or smell
coming from the
burner/appliance.
Flame is very
active going from
side to side.
Flames will not
extinguish when
turned off.
Burner won't light.
Spilled fuel
W415-0958 / C / 03.01.12
All manuals and user guides at all-guides.com
!
PROBLEM
Build up of dust or dirt on
appliance.
Foreign material in burn
pot / burner.
Incorrect fuel being used
Appliance was just turned
off.
Draft blowing on the
fl ame. (ie. Ceiling fan,
open window etc.)
Overfi lled burn pot /
burner.
Flame diverter pulled too
slowly, allowing vapour to
build up and burn through
the cracks.
Foreign material
obstructing fl ame diverter,
not allowing it to close.
Insuffi cient fuel.
Fuel is too cold.
Flame diverter is not fully
open.
Incorrect fuel being used
Spilled fuel
WARNING
TEST SOLUTION
- Clean the appliance
- Clean burn pot / burner
- Use only denatured ethanol
- The smell only lasts for a short period of time.
- Remove any air infl uence or relocate the appliance
when cool.
- People walking too close to the appliance. Relocate
to a low traffi c area when cool.
- Fill to appropriate level.
- Allow fuel to burn out completely.
- Open the fl ame diverter, allow the fl ame to settle and
then close with a faster motion.
- Allow fuel to burn out completely.
- Allow fuel to burn out completely.
- Clean burner.
- Fill to appropriate level.
- Allow some time for it to warm up.
- Open fl ame diverter completely.
- Use only denatured ethanol.
- Remove all ignition sources.
- Clean using an absorbant cloth to prevent ignition.
Dispose of cloth in a safe manner and keep away
from the appliance and ignition sources.
- Ventilate where spill occured.
- Only light the appliance when 100% sure spill has
been cleaned up.
42.21A