Napoleon WMFE1 Instructions D'installation Et D'utilisation page 12

12
5.2 GLASS FENDER INSTALLATION
A. Place the glass retaining pins into the holes with the set screws facing forward, as illustrated.
B. Slide the glass fender into the slots of the glass retaining pins. Center the glass.
C. Carefully tighten the set screws, making sure not to break the glass.
D. Lift the glass fender assembly out of the holes and rotate it 180°, so the set screws are facing the back
of the appliance.
5.3 WARNING PLATE LOCATION
The warning plate is located at the front edge of the
appliance. Pull it up, through the slot and tilt it back
to read. You may fi nd it easier to access with the
glass fender removed.
W415-0958 / C / 03.01.12
All manuals and user guides at all-guides.com
180°