Publicité
Les langues disponibles
Les langues disponibles
Setting Surface Controls
The Dual Radiant Elements
The cooktop is equipped with two dual radiant surface elements. The
size of graduations on the control panel (See Fig. 4) are used to
indicate which coil of the dual radiant element will heat. The small
graduations indicate that only the inner coil (See Fig. 2) will heat. The
large graduations indicate that both inner and outer coils (See Fig.
4) will heat. You may switch from either coil setting at any time during
cooking.
To Operate the Dual Element(s):
1. Place correctly sized cookware on the dual surface element.
2. Push in and turn the control knob counterclockwise (See Fig. 1)
for smaller cookware or clockwise (See Fig. 3) for larger cookware.
3. Use the ESEC digital display window for the desired setting. Turn
(do not push) the knob to adjust the setting if needed. Start most
cooking operations on a higher setting and then turn to a lower
setting to finish cooking. Each surface element provides a
constant amount of heat at each setting. A glowing red surface
heating area extending beyond the bottom edge of the cookware
indicates the cookware is too small for the surface heating area.
4. When cooking has completed, turn the surface control knob to
OFF before removing the cookware. Note: The HE message will
appear after turning the control knob to OFF if the cooktop is still
hot and will remain on until the radiant heating surface area has
cooled sufficiently. Note: See page 9, Fig. 1 for recommended
control settings.
Radiant surface elements may appear to have cooled after they have been turned off. The glass surface may
still be hot and burns may occur if the glass surface is touched before it has cooled sufficiently.
To Set the Cooktop Lockout Feature
C
LOCK
H
ORLOGE
The
pad is used to activate the Cooktop Lockout feature which will lock all surface elements from being accidentally turned
C
OOKTOP
T
ABLE DE
C
UISSON
ON. This feature will only lock the cooktop.
To turn the Cooktop Lockout Feature ON:
1. BE SURE ALL surface element controls are set to the OFF position.
C
LOCK
H
ORLOGE
2. Press and hold
until one beep is heard (after 3 seconds; See Fig. 5). If a triple beep sounds
C
OOKTOP
T
ABLE DE
C
UISSON
instead, check all surface elements and turn them to the OFF position and repeat this step. The
Cooktop Locked indicator light will turn ON and the cooktop controls and functions are locked out
until the cooktop is unlocked.
To turn the Cooktop Lockout Feature OFF:
1. BE SURE ALL surface element controls are set to the OFF position.
C
LOCK
H
ORLOGE
2. Press and hold
until one beep is heard (after 3 seconds). If a triple beep sounds instead, check all surface elements
C
OOKTOP
T
ABLE DE
C
UISSON
and turn them to the OFF position and repeat this step. The Cooktop Locked indicator light will turn OFF and the cooktop may
be used normally (See Fig. 6). Note: Starting a Self-Clean cycle will also turn ON the Cooktop Lockout feature. The cooktop
will remain locked until the Self-Clean cycle has completed and the oven door has unlocked. If a power failure occurs after the
Cooktop Lockout has been activated, you must turn OFF the Cooktop Lockout feature before being able to use the cooktop
features again.
All manuals and user guides at all-guides.com
10
O
Hi
Hi
Sim
Sim
Fig. 1
Fig. 2
O
Hi
Hi
Sim
Sim
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Publicité
