Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
Levelling
For good baking results, your range should be level. Screw type levelling legs are provided at each cor-
ner of the range at the base. Remove the storage drawer to adjust the levelling legs. (Refer to
Unlock
Lock
Locking the Front
Rollers (some models)
Setting Surface Controls
About the Ceramic Glass Cooktop
The ceramic cooktop has radiant surface
elements located below the surface of the glass.
The design of the ceramic cooktop outlines the
area of the surface element underneath. Make
sure the diameter of the pan matches the
diameter of the element outline on the cooktop
(See Fig 1). Heat is transferred up through the
surface of the cooktop to the cookware. Only flat-
bottom cookware should be used. The type and
size of cookware, the number of surface elements
in use and the settings, are all factors that will affect the amount of heat that will spread to areas beyond the surface
elements. The areas surrounding the elements may become hot enough to cause burns.
About the Radiant Surface Elements
The element temperature rises gradually and evenly. As the temperature rises, the element will glow red. To maintain the
selected setting, the element will cycle on and off. The heating element retains enough heat to provide a uniform and
consistent heat during the off cycle. For efficient cooking, turn off the element several minutes before cooking is complete.
This will allow residual heat to complete the cooking process.
All manuals and user guides at all-guides.com
(continued)
Storage Drawer section).
To level the range:
1. Use a 1¼" open end key or an adjustable wrench to equally
unscrew the four levelling legs two to three turns each.
2. Install an oven rack in the center of the oven.
3. Move the range to its final position, then put a spirit level on the rack to check for
levelness. Take two readings, one with the level placed diagonally first in one direc-
tion, and then the other.
4. Use the 1 ¼" key or wrench to adjust the levelling legs. Turn each one until the range
stands firm without wobbling.
5. Some models are supported by smooth glide rollers to facilitate moving.
If floor is flat and level, open the drawer and lower the front roller locking levers (some
models) to prevent the range from moving.
If floor is not flat or level or if this model has rollers without locking levers, use the 4
levelling legs to level, support and prevent the range from moving.
Circuit Protection
As a protection against surcharge, a 15 amp, 120 volt breaker is provided for each of
the electric outlet(s) (2 max.). It (they) is (are) located on top or underneath of the con-
trol panel. Models with no electric outlet have no breaker.
Ceramic Cooktop Design
7
Cooktop radiant areas that heat
Fig. 1
Publicité
