Johnson 40-6557 Mode D'emploi page 13

All manuals and user guides at all-guides.com
8489H-All_Manuals 11/18/14 11:50 AM Page 13
Tilt Mode
After turning on the laser, the laser will self-level and begin to
rotate. The TILT symbol LED will blink for 30 seconds after the
laser begins to rotate. During these 30 seconds if the laser is moved,
the laser will stop rotating, re-level and begin to rotate again. After 30
seconds, the TILT symbol LED will stop blinking and will become solid.
If the laser is moved when the TILT symbol LED is solid, the laser will
stop rotating. The laser beam will blink on and off and the TILT symbol
LED will blink quickly alerting the user that the height of instrument (H.I.)
may have been changed. Pressing the level vial button on the
laser keypad or remote will allow the laser to re-level and start rotating
again and the TILT mode will repeat. If the laser is operating in manual
mode and the TILT button is pressed, the laser will exit manual mode.
Speed Adjustment
After unit electronically self-levels, it rotates at its highest
speed (800rpm). Press the speed adjustment button (see figure) on
either the laser keypad or remote to change the rotating speed to its
low speed (300rpm) and 0rpm.
Note: During the self-leveling sequence, this key is not functional.
©2015 Johnson Level & Tool 13