Exit Bounzy Trampoline Mode D'emploi page 18

STEP 6
Insert the straight tube (7) into the frame
(1). Make sure the holes on the straight
Lay the Pad(5) on the Frame. Adjust
tube (7) and on the frame (1) are aligned.
Then tighten with one self-tapping screw
(12) using a tool.
Repeat this step to assemble the remaining
straight tubes.
Slide the Upper Tube() and Straight
STEP 7
Put the pole cap (13) on the top of the
straight tube (7).
STEP 6
Lay one Straight Tube() with Foam
and one Upper Tube() with Foam on
the ground. Insert the Straight
Tube(0) into the Upper Tube(0).
Secure with a Screw M().
Repeat this step to attach the five
remaining Straight Tube() and Upper
Tube(0) together (not shown).
18
13
7
6
12
7