Haier 6 Serie Instructions D'installation page 20

SECTION OF THE SUPPLY CABLE
TYPE "H05V2V2-F"
resistant to temperatures of 90°C
220-240 V 50-60 Hz

(*) Connection possible with plug and outlet

(**) Connection with wall box connection.
REPLACING THER POWER SUPPLY CABLE
WARNING: If the power supply cable is damaged, it must be replaced only by an
authorized service agent in order to avoid a hazard.
To connect the supply cable:
•
Unhook the terminal board cover by inserting a screwdriver into the two hooks "A" (fig.
3.1).
•
Open the cable gland by unscrewing screw "F" (fig. 3.2), unscrew the terminal screws
and remove the cable.
•
The new supply cable, of suitable type
and section, must be connected to the
terminal board following the diagram in
fig. 3.3.
•
Close and hook again the terminal
board cover.
NOTE: The earth conductor must be left
about 3 cm longer than the others.
The operations must be executed by a
qualified technician.
F
20 20
3 x 0,75 mm (*) (**)
2
A
Fig. 3.2
L
1
E
N (L )
2
Fig. 3.1
Fig. 3.3