Haier 6 Serie Instructions D'installation page 11

FASTENING THE COOKTOP
Each cooktop is provided with an installation kit including brackets and screws for fastening
the cooktop to benches from 30 to 40 mm thick.
The kit includes four "F" type brackets (for the front of the cooktop), three "R" type brackets (for
the rear of the cooktop) and seven self-threading screws "S".
• Cut the unit according to the dimensions in fig. 1.1a.
• Stretch gasket "G" over the edge of the hole made, being careful to overlay the junction
edges.
• Fasten the brackets "F" and "R" to the appropriate socket holes, without tightening the
screws "S" for the moment. Make sure that the tabs are mounted correctly, as shown
(figs. 1.2b, 1.2c). Rotate the tabs so that the cooktop can be put into the cutout.
• Put the cooktop into the cutout and position it correctly.
• Put the brackets "F" and "R" into place; tooth "A" of the brackets should go into the
hole (figs. 1.2b,1.2c).
• Tighten screws "S" until the cooktop is completely secured to the bench.
• Using a sharp cutter or trimmer knife, trim the excess sealing material around the edge
of the cooktop.

Take care not to damage the workbench.
R
Rear Fixing Brackets
Fig. 1.2b
G
R
F
A
R S
R
F
Fig. 1.2c
R
R
F
F
Front Fixing Brackets
G
A
S F
Fig. 1.2a
F
F
11 11