Publicité
Les langues disponibles
Les langues disponibles
RS10
5 . D escription of th e b uttons in th e circuit
A b b rev iation
A P / C H
Controls opening and closing the gate
E SC
Exit or go back to the lower level of the menu
▲ U P
Increases the displayed value by one unit or scrolling on the same menu level
▼ D O W N
Decreases the displayed value by one unit or scrolling on the same menu level
O K
Confirms the value or moves to the top level of the menu
P reliminary ch eck :
After powering up the control unit, the display shows the name of the control unit RS10, the firmware version Fxxx and then switches off. Check the dia-
gnostic LEDs of the inputs, the STOP, PHOTO, STPA, FCAP and FCCH LEDs must be on (if the limit switches are not engaged).
F O R O P E RA T IO N W IT H A MA IN S F RE Q U E N C Y O F 6 0 H Z F O L L O W
- disconnect the power supply to the control unit
- press the UP and DOWN buttons simultaneously
- power up while keeping the buttons pressed until the display shows 60 H
To return the control unit to operate at 50 Hz repeat the procedure, the display will show 50 H.
6 . Q uick programming
P rocedure f or f acilitated gate trav el programming:
N . B . : Before you start programming, check parameter 18 (opening direction)
If the gate opens to the right, set parameter 18 (opening direction) to R.
If the gate opens to the left, set parameter 18 (opening direction) to L
APERTURA
OPENING
All manuals and user guides at all-guides.com
EN
D escription
T H E IN ST RU C T IO N S:
APERTURA
OPENING
P arameter 18
on R
P arameter 18
on L
23
Publicité
