Publicité
Les langues disponibles
Les langues disponibles
Assembly
Read entire operator's manual before you
attempt to assemble or operate your new
pressure washer.
Your pressure washer requires some assembly and is
ready for use after it has been properly serviced with
the recommended oil and fuel.
If you have any problems with the assembly of your
pressure washer, please call the pressure washer
helpline at (800) 743-4115. If calling for assistance,
please have the model, revision, and serial number
from the identification label available.
Unpack Pressure Washer
1. Remove the parts bag, accessories, and inserts
included with pressure washer.
2. Open carton completely by cutting each corner
from top to bottom.
3. Ensure you have all included items prior to
assembly.
Items in the carton include:
• Main Unit
• Handle
• High Pressure Hose
• Spray Gun
• Nozzle Extension with Quick Connect
• Accessory Tray
• Oil Pouch
• Parts Bag (which includes the following):
• Operator's Manual
• Owner's Registration Card
• Ba g containing 3 Multi–Colored Spray Tips
• Handle Fastening Hardware Kit (which
includes):
• Carriage Bolts (2)
• Plastic Knobs (2)
• Tree Clips (4)
To prepare your pressure washer for operation,
you will need to perform these tasks:
1. Fill out and send in registration card.
2. Attach handle and accessory tray to main unit.
3. Add oil to engine crankcase.
4. Add fuel to fuel tank.
5. Connect high pressure hose to spray gun and
pump.
6. Connect water supply to pump.
7. Attach nozzle extension to spray gun.
8. Select/attach quick connect spray tip to nozzle
extension.
6
All manuals and user guides at all-guides.com
Attach Handle and Accessory Tray
NOTICE It may be necessary to move the handle
supports from side to side in order to align the handle
so it will slide over the handle supports.
1. Place handle (A) onto handle supports (B)
connected to main unit. Make sure holes (C) in
handle align with holes (C) on handle supports.
A
C
B
2. Insert carriage bolts (D) through holes from back
of unit and attach a plastic knob (E) from front of
unit. Tighten by hand.
D
3. Place accessory tray (F) over holes (G) on handle
(viewing from front of unit). Push the tree clips (H)
into the holes until they sit flat against the accessory
tray.
4. Insert multi–colored spray tips and other supplied
accessories in spaces provided in accessory tray.
See How to Use Accessory Tray.
BRIGGSandSTRATTON.COM
C
E
G
H
F
Publicité
