Publicité
Les langues disponibles
Les langues disponibles
◼ Unscrew the oil filter cup.
◼ Blow out the oil filter cup thoroughly
with compressed air against the
direction of the arrow.
◼ Place new rubber sealing ring on
sealing surface of oil filter cup and
screw oil filter cup back in.
Troubleshooting
The engine will not start.
◼ Check whether the on/off switch or the
key switch (for generators with electric
starter) is in the operating position -
"ON" position.
◼ Check the engine oil level. If the oil
level is too low, the engine cannot be
started.
◼ Check if there is fuel in the fuel tank.
◼ Disconnect the spark plug connector,
remove the spark plug with the spark
plug wrench and check its condition.
− Use a wire brush to remove soot
particles from the spark plug and
electrodes.
− Check the electrode gap and adjust
it to 0.7 to 0.8 mm if necessary.
The generator does not produce
any current.
◼ Connect a hand lamp to the generator
to check.
◼ Check that the AC fuse switch is in
the "ON" position.
CAUTION!
Observe:
If the generator still does not start 0or does
not generate power, contact your dealer or
an authorized service shop for further
troubleshooting.
Cleaning instructions
CAUTION!
Keep the power generator clean.
38
All manuals and user guides at all-guides.com
Original User Manual Generator FX-SG Series
Neglecting cleaning measures may lead to
material damage and malfunctions.
Do not spray the power generator
with water.
◼ Keep ventilation slots clean and free of
dust.
◼ Use a soft cloth and a soft brush for
cleaning the exterior.
◼ Clean the tank cover seals regularly
and replace them if necessary.
Storage
NOTE!
Always store the power generator in a
clean, dry, and frost-free place.
If the current collector is to be stored for a
more extended period, proceed as follows:
◼ Shut off fuel tap and unscrew oil filter
cup counterclockwise, drain and blow
out clean.
◼ Position a suitable drain container under
the drain, open the fuel tap, and drain
the fuel entirely into the box.
◼ Replace a sealing ring (rubber) and
screw the oil filter cup back in
clockwise.
◼ Loosen carburettor drain plug and drain
residual fuel from the carburettor into a
suitable container. Tighten carburettor
drain plug again.
◼ Unscrew the oil filler cap, unscrew the
oil drain plug and completely drain oil
from the crankcase into a suitable
container.
◼ Retighten the oil drain plug and fill it
with suitable engine oil up to the
dipstick's upper mark. Screw the oil
filler cap back into the oil filler neck.
Pull until resistance is felt.
◼ Pull the starter rope in doses until
resistance is felt.
Publicité
