FUXTEC FX-SG3800 Mode D'emploi page 33

Before commissioning
Check the power generator for completeness
of delivery and transport damage.
NOTE
Immediately report any damage to the
generator or defective or missing parts to
the supplier or manufacturer!
Scope of delivery
The scope of delivery includes
− Power generator set
− User manual
Inspection work
WARNING!
Before carrying out any work on
components, secure the power generator
on a flat, stable surface and protect it
against unauthorized switches.
CAUTION!
Do not start up the power generator until
you have carried out all the necessary
assembly, adjustment, and inspection
work on the power generator have been
carried out.
Checking the engine oil level
NOTE
The engine will not start if the engine oil
level is too low.
NOTE
Make sure that no oil flows next to it when
topping up engine oil. Wipe off leaks so- fort
with clean rag.
32
All manuals and user guides at all-guides.com
Original User Manual Generator FX-SG Series
◼ Unscrew the oil filler cap together with
the oil dipstick from the filler neck and
pull it out. Clean the dipstick with a
clean cloth.
◼ Insert the dipstick into the oil filler
neck without screwing it in.
◼ If the oil level is below the lower limit
mark, fill the recommended oil up to the
upper limit mark.
◼ Screw the oil filler cap firmly back
onto the oil filler neck.
Filling up with fuel
DANGER!
Pay special attention to the safety
instructions in the chapter "Explosion and
fire hazard" as well as to the safety stickers
on the
generator!
◼ Unscrew the cap on the fuel tank.
◼ Check the filling level. If necessary, fill
the tank to a maximum of the upper
edge of the filter.
◼ Screw the fuel tank cap tightly back
onto the fuel tank nozzle.
Checking the air filter
◼ Loosen the clamping straps (Q) at
the top and bottom of the air filter
housing.
◼ Check the condition of the air filter;
replace the air filter if it is damaged.
◼ Clean the air filter if it is dirty as
follows:
− Wash the filter element in the
washing solution.