Publicité
Les langues disponibles
Les langues disponibles
Technical information / Functioning / Parameters
Adjustable parameters
Switch-on point: Upper limit value at which the output
changes its switching status.
Switch-off point: Lower limit value at which the output
changes its switching status.
rP1 is always lower than SP1. The unit only accepts values which
are lower than SP1.
Changing the switch-on point also changes the switch-off point
(the hysteresis remains constant).
If the hysteresis is higher than the new switch point, it is
automatically reduced (rP1 is set to the minimum setting value).
Setting range:
Configuration of the switching output
4 switching functions can be set:
• Hno = hysteresis / normally open
• Hnc = hysteresis / normally closed
• Fno = window function / normally open
• Fnc = window function / normally closed
Configuration of the analogue output
2 options can be set:
• I = 4 ... 20 mA
• U = 0 ... 10 V
Lower end of analogue output
Measured value for which the output signal is 4 mA / 0 V.
Upper end of analogue output
Measured value for which the output signal is 20 mA / 10 V.
Minimum distance between ASP and AEP: 50°C / 90°F.
Setting range:
24
All manuals and user guides at all-guides.com
SP1
°C
-39.8 ... +300.0 -40.0 ... +299.8
°F
-39.6 ... +572.0 -40.0 ... +571.6
ASP
°C
-40.0 ... +250.0 +10.0 ... +300.0
°F
.-40.0 ... +482,0 +50.0 ... +572.0
rP1
in steps of
AEP
in steps of
0.1
0.1
0.1
0.1
Publicité
