Miele PDR 910 EL Schéma D'installation page 38

en - Technical data
Equipotential bonding
Connection with male thread
Washers and nuts
If local and national installation specifications require equipotential bonding, good galvanic contact must be guaranteed. Accessories
for equipotential bonding are not supplied and need to be ordered separately.
Peak-load negotiation (optional)
Supply voltage for control contacts
Minimum cross-section for connection cable
Miele recommends using a flexible connection cable with an additional isolation option to establish the connection. The isolator should
remain visible once the tumble dryer has been installed and must be freely accessible.
Machine data
Appliance width, total
Appliance height, total
Appliance depth, total
Niche width
Recommended wall spacing (up to the front edge of the machine)
Minimum wall spacing (up to the back edge of the lid)
Packaging width
Packaging height
Packaging depth
Maximum gross volume
Maximum gross weight
Maximum net weight
Max. floor load in operation
Diameter of exhaust duct
Drum diameter
Diameter of drum opening
Drum depth
Drum volume
Diameter of door opening
Maximum door opening angle
Emission sound pressure level
Sound power level
Average heat dissipation rate into the room
Permissible ambient temperature range
WiFi frequency band
Maximum WiFi transmission power
38
10×35 mm
M10
AC 230 V
5×1,5 mm²
700 mm
1020 mm
763 mm
820 mm
1300 mm
500 mm
760 mm
1215 mm
820 mm
757,2 l
80 kg
72 kg
853 N
100 mm
649 mm
452 mm
550 mm
180 l
452 mm
162°
50 dB(A) re 20 µPa
58
n/a MJ/h
2–40 °C
2,4000–2,4835 GHz
<100 mW