Publicité
Les langues disponibles
Les langues disponibles
Then, lift the dust bin cover and remove the plastic insert from the bin – see figure below.
Fill the bin with tap water up to the MAX marking, as shown in the figure below.
Required water amount is 0.8 litre. Be careful not to overfill past the MAX marking. When the bin is
filled, replace the insert into the dust bin and replace the cover. Then, replace the entire bin assembly
onto the vacuum cleaner. Take care to correctly assemble all components.
CONNECTING THE FLEXIBLE SUCTION HOSE
Connect the flexible hose to the suction port and press it until it locks into position.
REMOVING THE HOSE
To remove the suction hose, press the button on the lower part of the flexible suction hose and pull it
out of the suction port.
UNWINDING AND RETRACTING THE POWER CORD
•
Before using the appliance, unwind an adequate length of the power cord to allow unobstructed
work. Then, connect the appliance to the power mains. To retract the power cord, press the automatic
cord reel button. Follow the power cord with your hand to prevent it from swinging out of control and
causing injury or damage. When using the appliance for a longer period of time, unwind the entire
length of the power cord from the reel.
17
Publicité
