Operation - Bartscher 151.510 Mode D'emploi

Сonnection
•
The dual model (151.511) is powered at 400 V. The device is delivered without a
plug. The device may be connected only by qualified personnel in accordance with
applicable regulations. With regards to the installation, a multi-pole distributor, with
3mm minimum spacing of contacts (e.g. fuse, safety switch). It is forbidden to install
the device without such a switch.
•
The device must be grounded. A grounding switch is located on the right side of the
device. Connect the grounding switch with the help of a grounding cable (diameter
min. 2mm), in accordance with applicable safety regulations.

5.3 Operation

Electric lift salamander functions
You have purchased professional equipment which allows you to quickly bake the
surface of foodstuffs making them especially crunchy. An adjustable-height heating
element utilizing infrared heat is integrated into a casing of stainless steel. Owing to this
it is possible to work quickly and efficiently, always getting the best results.
If you have purchased the dual model 151.511, dual temperature controls allow you to
set different temperatures for the left and right sides of the device as needed, or simply
turn one side off.
Removal of the grease tray, along with the stainless steel grill surface, make it easier to
place foodstuffs in the device and easier to clean.
Starting the device
•
Ensure that the temperature regulator is set to the position marked „OFF".
•
Prior to first use clean the device (see sec. 6.2 "Cleaning")
•
Connect the device to a single grounded socket (this does not apply to the dual
model 151.511).
•
When the device is connected to the socket, the network control light comes on.
•
Using the handle, raise the upper part of the device with heating elements and place
foodstuffs on the grill surface.
•
Set the desired temperature. With the dual model 151.511, it is possible to set a
separate temperature for each heating area. The temperature range of the salamander
is from 0 to 400° C. The recommended temperature is between 300° C and 400° C.
•
The green control lamp, when lit, indicates that the device is warming up.
- 24 -