Installation And Operation; Installation - Bartscher 700475 Mode D'emploi

5. Installation and operation

5.1 Installation

CAUTION!
Installation and maintenance operations may only be performed by qualified
professionals!
Positioning
•
Unpack the device and remove the packing materials.
CAUTION!
Never remove the identification plate or warning signs from the device.
•
Leave the device on its pallet.
•
Raise the deep freezer using a pallet jack and place it where it is intended to be
located.
•
Do not push or pull the deep freezer as it may tilt, causing damage to the external
casing and adjustable legs.
•
When the deep freezer is placed in its intended location, remove the pallet.
Take care not to hit the device.
•
Place the device in a flat, secure place that will support its weight.
•
Set up the device using the adjustable legs. Use a level as needed. Every leg
must touch the floor, as otherwise the door may open and close improperly.
•
Remove the protective foil from the device.
•
Not at any time should you place the device on an inflammable surface.
•
Do not place the device in the vicinity of open sources of fire, electric cookers,
furnaces or other sources of heat such as e.g., in places exposed to direct sunlight.
The heat can damage the surface of the device, as well as have a negative effect on
the cooling power and increase the consumption of energy.
•
To avoid damage to the compressor, do not tilt the device to an angle greater than 45°
during setup or transport. Be careful when touching the condenser and doors, as
damage to them will negatively impact the working of the device.
- 30 -