Publicité
Les langues disponibles
Les langues disponibles
OPERATING THE SWASH
Using the LES512
NOTE: The wash functions will not work
unless the sensor in the seat detects
someone sitting down (with the built-in
skin conductivity sensor). To override the
Seat Sensor, please see the instructions on
page 17.
Prepare for Wash
Sit on the seat to ensure skin-to-seat contact
on the Seat Sensor. Once contact is made
the water pressure indicator lights will turn
on.
Warm Water Wash
When ready to wash, press the Rear Wash,
Front Wash, or Strong Wash button on
the control panel one time to initiate a wash.
The nozzle will self-clean, extend into
the toilet bowl, spray for two minutes, turn
off automatically, retract, and self-clean
once again.
1. Pressing the Rear Wash, Front Wash,
or Strong Wash button a second time
while the wash is running will cause the
nozzle to oscillate forward and backward,
providing a wider range of wash spray.
Press again to cancel the Move function.
2. While washing, users can adjust the
water temperature, pressure, and nozzle
position settings, as well as initiate the
Pulse feature by following the notes on
page 15.
3. If you would like to stop the wash before
the two-minute cycle ends, press the Stop
button to discontinue water flow.
4. After extended use the water may
decrease in temperature if a Low, Medium,
or High water temperature setting is
selected. To regain warmer water, stop all
wash functions for three minutes to allow
the bidet to reheat the water.
16
Warm Air Dryer Function
Press the Dry button to activate the Warm
Air Dryer. The dryer will run for two minutes
and turn off automatically.
1. While the air dryer is operating, users
can adjust the dryer temperature to a
comfortable level using the Dry Temp "+"
and "–" buttons. The dry temperature will
be reflected on the five indicator LEDs.
2. If you would like to stop the dryer before
the two minutes has elapsed, press Stop.
Gentle Mode
All settings within Gentle Mode are 40%
softer than standard wash modes.
Once activated, gentle mode will begin a
two-minute wash including:
• Full nozzle extension
• Water Pressure set to low
• Front Wash for one minute, Nozzle
Oscillation for 30 seconds, then Pulse
for 30 seconds
After the wash cycle is over, Gentle Mode
will initiate a two minute Warm Air Dry cycle
on Level Two.
NOTE: While the Gentle Mode cycle
is running, the Water Pressure setting
is adjustable. Dryer settings are also
adjustable during the Gentle Mode.
Publicité
