Télécharger Imprimer la page

Panasonic EYFLF1XA Instructions D'utilisation page 21

Publicité

Les langues disponibles

Les langues disponibles

• Use figures from the Tightening Torque
Chart to guide your selection of torque
clutch setting. (See the following tighten-
ing torque chart)
2. Press the OK button to accept the select-
ed torque clutch setting.
• The control panel will stop flashing and
light up.
CAUTION:
• You must press the OK button in order
for the selected setting to take effect.
• Be sure to verify the new value after
changing the setting.
[EYFLF]
Tightening Torque Chart (for
Reference Use)
The values illustrated on this chart were mea-
sured under the conditions described below
and are provided for reference purposes.
Actual tightening torque varies with ambient
conditions (the particular bolt being tightened,
hardware being used, method of holding the
bolt in place, etc.).
[Fig.16]
Measurement conditions
• Temperature: Room temperature (20 °C/68 °F)
[EYFLF]
Setting the snug point detection level
[Fig.17]
1. Press the A button.
• The snug point detection level setting
value will be displayed.
[Fig.18]
2. Press the
and
best snug point detection level for the
work you're performing.
3. Press the OK button to accept the number
of torque stages and the snug point detec-
tion level.
The tool's panel will flash and then light up
continuously.
Snug point detection level guidelines
[Fig.19]
[Fig.20]
buttons to set the
‒ 21 ‒
CAUTION:
• The setting will not be changed until you
press the OK button.
• After changing the setting, be sure to
check the new setting value. (See
"Checking Tool Settings.")
• Set the snug point detection level from
"L1." Setting the snug point detection
level from "L7" may result in cracking or
deformation of the target material.
• If the tool stops before the snug point at
snug point detection level "L1," set the
snug point detection level to "L7."
• Changing the snug point detection
level from "L1" to "L7" may increase the
torque. Set the number of torque stag-
es again after making this change.
[EYFLF]
IMPORTANT INFORMATION:
• Pressing the A button toggles the display
between the snug point detection level
setting value and the number of torque
stages setting value.
• The tool ships with the snug point detec-
tion level set to "L1."
• When the number of torque stages has
been set as shown below, the snug point
detection level cannot be switched from
"L1" to "L2 ~ L7."
Number of torque stages
Model
EYFLF1
EYFLF2
[EYFLF]
Cross thread reduction function
The tool reverses approximately 360° or 180°
before moving forward to align the threads
and reduce cross-threading.
1. Set the tool to setting configuration mode.
(See page 20.)
2. Press the D button once.
The cross thread reduction function set-
ting value will be displayed.
[Fig.21]
3. Press the
and
setting to ON or OFF.
setting
1 to 40
1 to 40
buttons to change the
EN

Publicité

loading