HYDAC International CS1000 Serie Notice D'utilisation Et De Maintenance page 43

ContaminationSensor CS1000
Analog output (ANaOUT)
Restart measurement, discard changes (CANCEL)
Restart measurement, save changes (SAVE)
Menu CS 13xx (ISO 4406:1987 et NAS)
Menu Power Up
Measuring mode (MODE)
Measuring time (mTIME)
Pump protection (pPRTCT)
Bus address (ADRESS)
Factory defaults (DFAULT)
Calibration selection (CALIB)
Cancel (CANCEL)
Save changes, leave Power Up Menu (SAVE)
For internal use (CODE)
Measuring Menu
Display (DSPLAY)
HYDAC Filtertechnik GmbH
BeWa CS1000 3247149n fr 2009-02-04.doc
Vue d'ensemble de la structure des menus
Mode "1" (M1)
Mode "2" (M2)
Mode "3" (M3)
Mode "4" (M4)
Mode "Single" (SINGLE)
Set value (60)
Set value (0)
HECOM3b address (HECOM)
(IP) reserved for future use
(MODBUS) reserved for future use
ISO99/SAE (ISoSAE)
ISO87/NAS (ISoNAS)
ISO-Code (ISO)
NAS-class 2 (NAS 2)
NAS-class 5 (NAS 5)
NAS-class 15 (NAS 15)
NAS-class 25 (NAS 25)
NAS Maximum (NAsMAX)
Flow rate (FLOW)
Analog output (ANaOUT)
Measuring cell LED current (DRIVE)
Temperature (TEMP C)
Temperature (TEMP F)
fr
SAE A-D (SAeMAX)
SAE class A/B/C/D (SAE)
SAE class A/B/C/D + Temperature (SAE+T)
Temperature (TEMP)
HDA+ISO (HDaISO)
HDA+SAE (HDaSAE)
ISO-class 4µm (ISO 4)
ISO-class 6µm (ISO 6)
ISO-class 14µm (ISO 14)
ISO Code (ISO)
ISO Code + Temperature (ISO+T)
SAE A (SAE A)
SAE B (SAE B)
SAE C (SAE C)
SAE D (SAE D)
Set value (A)
Page 43 / 98
2009-02-04