HYDAC International CS1000 Serie Notice D'utilisation Et De Maintenance page 42

ContaminationSensor CS1000
Vue d'ensemble de la structure des menus
Menu CS 12xx (ISO 4406:1999 et SAE)
Menu Power Up
Measuring mode (MODE)
Measuring time (mTIME)
Pump protection (pPRTCT)
Bus address (ADRESS)
Factory defaults (DFAULT)
Cancel (CANCEL)
Save changes, leave Power Up Menu (SAVE)
For internal use (CODE)
Measuring Menu
Display (DSPLAY)
Switching output (SWtOUT)
HYDAC Filtertechnik GmbH
BeWa CS1000 3247149n fr 2009-02-04.doc
Vue d'ensemble de la structure des menus
Mode "1" (M1)
Mode "2" (M2)
Mode "3" (M3)
Mode "4" (M4)
Mode "Single" (SINGLE)
Set value (60)
Set value (0)
HECOM3b address (HECOM)
(IP) reserved for future use
(MODBUS) reserved for future use
ISO-Code (ISO)
SAE-class A (SAE A)
SAE-class B (SAE B)
SAE-class C (SAE C)
SAE-class D (SAE D)
SAE A-D (SAeMAX)
Flow rate (FLOW)
Analog output (ANaOUT)
Measuring cell LED current (DRIVE)
Temperature (TEMP C)
Temperature (TEMP F)
Mode "1" (M1)
No settings necessary (NO SET)
Mode "2" (M2)
Switching point (SP1)
Mode "3" (M3)
Measuring Channel (MEAsCH)
Target cleanliness (TARGET)
Mode "4" (M4)
Measuring Channel (MEAsCH)
Target cleanliness (TARGET)
Upper limit (RSTART)
Test cycle time (CYCLE)
Mode "Single" (SINGLE)
fr
Set value (A)
Measuring channel (MEAsCH)
SAE A-D (SAeMAX)
SAE class A/B/C/D (SAE)
ISO-class 4µm (ISO 4)
ISO-class 6µm (ISO 6)
ISO-class 14µm (ISO 14)
ISO Code (ISO)
Temperature (TEMP)
SAE-class A (SAE A)
SAE-class B (SAE B)
SAE-class C (SAE C)
SAE-class D (SAE D)
Switching function (SwFNCT)
Beyond limit (BEYOND)
Below limit (BELOW)
Within band (WITHIN)
Outside band (OUTSDE)
No switch (OFF)
Limits (LIMITS)
Lower limit (LOWER)
Upper limit (UPPER)
ISO (ISO)
SAE (SAE)
ISO (ISO)
SAE (SAE)
Set value (60)
Page 42 / 98
2009-02-04