SOMFY Sunea CMO RTS Notice page 23

Sunea CMO RTS
Using the Up button
Up button to raise the awning completely and return to the standard operating mode
Using the Down button
Down button to lower the awning for 1.5 seconds and raise until it stops when
the torque is detected, then lower again to the lower end limit and return to the standard operating
mode.
Wind rising
When the wind speed exceeds the threshold set on the RTS wind sensor a raising command is sent
to the motor.
The awning is raised to the upper end limit and returns to the standard operating mode.
The sun function is inactive until a raising, lowering or wind rising operation has reset the
motor to the standard operating mode.
3.9. TIPS AND RECOMMENDATIONS FOR USE
3.9.1. Questions about the Sunea CMO RTS?
Observations
The motorised product
does not operate.
If the motorised product still does not work, contact a motorisation and home automation professional.
3.9.2. Replacing a lost or broken Somfy control point
To replace a lost or broken control point, contact a motorisation and home automation professional.
4. TECHNICAL DATA
Power supply
Radio frequency
Operating temperature
Index protection rating
Safety level
Maximum number of control points
Maximum number of sensors
Copyright 2009 - 2017 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
©
Possible causes
The control point battery is weak.
The motorisation is in thermal
protection mode.
Solutions
Check whether the battery is weak and replace
it if necessary.
Wait for the motor to cool down.
120V~ 60Hz
433,42 MHz
- 20°C to + 60°C
IP 44
Class I
12
3
EN
23