Publicité
Les langues disponibles
Les langues disponibles
EN
2. INSTALLATION
Instructions which must be followed by the drive and home automation professional installing
the Sunea CMO RTS drive.
Never drop, knock, drill or submerge the drive.
Install a separate control point for each drive.
2.1. INSTALLATION
2.1.1. Preparing the drive
Check that the inner diameter of the tube is 47mm or greater.
1) Fit the accessories required to integrate the drive in the
roller tube:
b and the drive wheel c on the drive.
2) Measure the length (L1) between the inner edge of the
drive head and the rim of the drive wheel.
2.1.2. Tube preparation
1) Cut the roller tube to the required length, depending on the
motorised product.
2) Deburr the roller tube and remove the swarf.
3) For roller tubes which are smooth inside, cut a notch with
the following measurements:
d = 4 mm /0.16 In ; e = 28 mm /1.1 In.
2.1.3. Drive/tube assembly
1) Slide the drive into the roller tube.
For roller tubes which are smooth inside, position the notch
previously cut on the boss on the crown.
2) The drive wheel must be locked in place to prevent it
moving along the roller tube:
•
drive wheel using 4 x Ø 5 mm self-tapping screws, or by
using 4 x Ø 4.8 mm steel pop rivets placed 5 mm to 15
mm from the outer rim of the drive wheel, regardless of
the roller tube.
The screws or pop rivets must only be attached to the drive wheel and not to the drive.
•
Alternatively, a drive wheel stop can be used for tubes which are not smooth.
2.1.4. Fitting the emergency crank
-
7 mm hexagonal pin (D) (accessories not supplied).
Attach the appropriate crank handle to the motor head.
-
14
a on the drive.
Copyright
2009 - 2017 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
©
1)
Ø = 47 mm
a
2)
L1 = ...
L1
1)
2)
3)
d
1
2
15 mm
L1
D
C
Sunea CMO RTS
Ø > 47 mm
b
c
e
5 mm
20 mm
Publicité
