Publicité
Les langues disponibles
Les langues disponibles
EN
2.3. COMMISSIONING
2.3.1. Pre-programming the RTS control point
1) Switch on the power supply.
2) Press the Up and Down buttons on the RTS control point
at the same time: The motorised product moves up and down
(fast raising and lowering), and the RTS control point is pre-
programmed in the motor.
2.3.2. Checking the direction of rotation
1) Press the UP button on the RTS control point:
a) If the motorised product rises (a), the direction of
rotation is correct: Move onto the section entitled "Setting
the end limits".
b) If the motorised product lowers (b), the direction of
rotation is incorrect: Move onto the next step.
2) Press the my button on the RTS control point until the
motorised product moves up and down: The direction of
3) Press the UP button on the RTS control point to check the
direction of rotation.
2.3.3. Setting the end limits
Settings for cassette awnings
For cassette awnings, the upper end limit is set automatically, while the lower end limit must be set.
Setting the lower end limit
Do not use the "my" and Down buttons at the same time to reach the lower end limit.
Set the awning to the lower end limit.
1)
Press and hold the Down button for > 2 seconds to lower
the awning in a single movement.
Stop the awning in the desired position.
2)
If necessary, adjust the position of the awning using the Up
3)
and Down buttons..
Press the my and Up buttons simultaneously: The awning
4)
is raised in one continuous movement even after the my
and Up buttons have been released.
5)
awning.
Press the my button again until the awning makes a
6)
movement (1.5 seconds downwards then upwards until the
cassette closes): The end limits have been programmed.
Wait for the awning to stop completely before going to the
16
my button to stop the
Copyright
2009 - 2017 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
©
1
a
Setting the end limits
b
Go to the following step
2
3
1
2
3
4
5
6
Sunea CMO RTS
Publicité
