Publicité
Les langues disponibles
Les langues disponibles
Sunea CMO RTS
Settings for non-cassette awnings
For non-cassette awnings, the upper and lower end limits must be set.
Setting the upper end limit
Set the awning to the upper end limit.
1)
Press and hold the Up button for >2 seconds to raise the
awning in one continuous movement.
Stop the awning in the desired position.
2)
If necessary, adjust the position of the awning using the Up
3)
and Down buttons.
Press the my and Down buttons simultaneously : the
4)
awning is lowered in one continuous movement even after
the my and Down buttons have been released.
5)
awning and go to the following step.
Setting the lower end limit
Set the awning to the lower end limit.
1)
Press and hold the Down button for >2 seconds to lower the awning in one continuous
movement.
Stop the awning in the desired position.
2)
If necessary, adjust the position of the awning using the Up
3)
and Down buttons.
Press the my and Up buttons simultaneously: The awning
4)
is raised in one continuous movement even after the my
and Up buttons have been released
5)
awning.
Press the my button again until the awning makes a
6)
movement (1.5 seconds downwards then upwards until the
awning closes): the end limits have been programmed.
Wait for the awning to stop completely before going to chapter
to stop completely before going to the stage entitled "Setting
2.3.4. Recording the RTS control point
The motorisation is in programming mode:
-- Quickly press the PROG button on the RTS control point to
be programmed:
control point is programmed in the motorisation.
If the motorisation is no longer in programming mode, repeat Step 2.3.1 then perform Step
2.3.4.
Copyright
2009 - 2017 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
©
my button to stop the
my button to stop the
1
2
3
4
5
Go to the following
1
2
3
4
5
6
PROG. H
EN
step
17
Publicité
