SOMFY Sunea CMO RTS Notice page 21

Sunea CMO RTS
Only switch off the power to the application to be reset.
This reset deletes all control points, all the sensors and
all the end limit settings, and resets the motor's favourite
position (my).
Position the motorised product at the mid-height position.
1)
Cut the power supply for 2 seconds.
2)
Switch the power supply back on for 5 to 15 seconds.
3)
Cut the power supply for 2 seconds.
4)
Switch the power supply back on: the motorised product
5)
moves for a few seconds. (If the application is at the
upper or lower end limit, it will make a brief up and down
movement).
Press the PROG button on the Somfy local control point for
6)
down twice:
Repeat the
-
Commissioning) section.
3. USE AND MAINTENANCE
This drive is maintenance-free
3.1. UP AND DOWN BUTTONS
Pressing the UP or DOWN button fully raises or lowers the
motorised product.
For cassette awnings, the obstacle detection is active
throughout the descent.
3.2. STOP FUNCTION
The motorised product is moving.
press my: the motorised product stops automatically.
-
3.3. FAVOURITE POSITION (my)
Besides the upper and lower positions, an intermediate
position known as the "favourite position (my)" is programmed
as standard in the Sunea CMO RTS.
To use the favourite position (my):
press my: the motorised product starts to move, and stops in the favourite position (my).
-
To modify or delete the favourite (my) position, see the section entitled "Additional settings".
Copyright 2009 - 2017 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
©
motorised product moves up and
commissioning procedure
1
5 s
3
ON
15 s
5
ON
6
PROG.
(see
1
2
3
EN
2
OFF
2 s
4
OFF
2 s
my
my
21