Shut off the engine.
N
Fit the blade scabbard.
N
Pull back the sliding sleeve (1) and
N
use the lever (2) to swing the joint
upwards – in direction of drive tube
– until the cutter bar is flat against
the drive tube.
Release the sliding sleeve (1) and
N
make sure the lock pin engages the
quadrant (3).
The sliding sleeve butts against the
housing when the pin is properly
engaged (after making adjustment).
HL 100, HL 100 K
All manuals and user guides at all-guides.com
Fitting the Harness
Some versions of the machine can be
carried on a harness.
The type and style of the harness
depend on the market.
Shoulder strap
3
Put on the shoulder strap (1).
N
Adjust the length of the strap.
N
With the power tool attached, the
N
carabiner (3) must be at about the
same height as your right hip.
Full harness
1
Put on the full harness (2).
N
Adjust the length of the strap.
N
With the power tool attached, the
N
carabiner (3) must be at about the
same height as your right hip.
English
2
3
15