Assembling the Unit
Mounting the Loop Handle
Necessary on versions with long drive
tube and 135° adjustable cutter bar (not
on HL 100 K).
7
8
2
3
6
9
Place the clamp (1) in the loop
N
handle (2) and position them both
against the drive tube (5) between
the carrying ring (3) and handle
hose (4).
Place the clamp (6) against the
N
drive tube.
Line up the holes.
N
Insert the screws (7) with
N
washers (8).
Fit the square nuts (9) and screw
N
home the screws.
HL 100, HL 100 K
All manuals and user guides at all-guides.com
7
8
Align the loop handle (2) and move
N
it to the most comfortable position.
1
Distance (A) must not be more than
55 cm (recommended: about 35 cm).
Tighten down the screws firmly.
N
9
Mounting the Gearbox
A
2
N
N
Loosen the clamp screws (9).
Push the gearbox (10) onto the
drive tube (5), turn the gearbox (10)
back and forth as necessary.
English
11