Publicité
Les langues disponibles
Les langues disponibles
To t urn of f t he m onit or
Press 1/u on the remote control. The monitor enters
standby mode and the STANDBY indicator lights up.
To turn off the main power, press u switch on the
monitor.
Not e
To protect the lamp, the picture and sound will not turn on
immediately if you try to turn on the power more than 5 seconds
after the power has been turned off. If you turn the monitor back
on within about 5 seconds after power-off, the picture and sound
will reappear immediately.
M ut ing t he sound
Press MUTING on the remote control.
"MUTING" appears on the screen.
To restore the sound, press MUTING again, or press
VOL+.
Displaying on-screen inf orm at ion
Press DISPLAY on the remote control to display the
following information on the screen.
Current input
RGB 1
signal
* fH: Horizontal frequency
fV: Vertical frequency
"OUT OF SCAN RANGE" appears if the scanning
frequency range is not w ithin the acceptable
limits. (See page 9.)
To make the on-screen information disappear, press
DISPLAY again.
16
-GB
Operat ions
Downloaded from:
https://www.usersmanualguide.com/
fH: 37.5kHz
Current input signal
fV: 75Hz
frequency w hen
the RGB signal* is
input
Adjust ing t he
com put er pict ure
Adjust ing t he posit ion (CENTER)
After projecting the picture from a computer, you may
need to adjust the position of the picture to fit the
monitor screen. You can also move the picture as you
like. The setting is only for the input signal displayed
on the screen.
MENU
1
Press M ENU.
MENU
2
Press v or V t o select "
press ENTER.
3
Press v, V, B or b t o adjust t he posit ion.
For horizontal adjustment press B or b.
b : to move the picture right
B : to move the picture left
For vertical adjustment press v or V.
V : to move the picture up
v : to move the picture dow n
ENTER
(CENTER)," and
C E N T E R
ENTER
EX I T
Publicité
