Publicité
Les langues disponibles
Les langues disponibles
EN
Remove the brackets from the appliance doors and
using measurements (A) and (B) attached the brackets
to the door overlay panels centered horizontally.
Please follow the steps below to mount the door overlay
panel and the refrigerator door.
Use screwdriver to turn
the bolt and adjust the upper
and lower clearance between
the wooden door and the
cabinet .
Fixing base
16
5
6
Use the # 13 wrench to adjust the nut, adjust the left
and right and front and back clearance between the
wooden door and the cabinet.
Reversing the appliance doors
We recommend you seek the help of another individual
to support the doors while performing this operation.
1. Remove the screws connecting the doors to the hinges.
Place the doors to the side.
2. Pop out the plastic screw hole covers from the positions
where you will relocate the hinges to. Save these plugs.
3. Remove the screws connecting the hinges to the body of
the appliance.
4. Move the hinge positions diagonally for each door and
rotate 180˚ and fix to the new position.
5. Use the plugs to cover the newly exposed screw holes
where the hinges once were.
6. Use the extra hinge covers for opposite positioning to
finish the look.
7. Reattach the door panels to the hinges.
Ensuring the door seals correctly:
It is normal for the seal to be compressed after the door has
been reversed. With the door closed, use a hair dryer to
expand the seal and fill the gap between the door and the
body of the appliance. Take care not to use the hair dryer
too close to the appliance, which could damage the seal. A
distance of approximately 10cm (4") should be adequate.
When completed, allow the seal and door to cool before
touching them. Once done, the seal should remain in
position.
Publicité
