Publicité
Les langues disponibles
Les langues disponibles
Instructions for Ice Maker
1. Connect the waterline connector to water source, and
check for any connector leakages after water is supplied.
2. Open the freezer door, pull out the ice box, and turn on
the ice maker for ice making; then, install back the ice
box.
3. The ice maker indicator shows yellow and is flashing,
indicating that ice making is in process.
4. The ice maker indicator shows yellow and is not flashing,
indicating that the ice box is full and ice making is
paused.
5. The ice maker indicator shows red and is flashing,
indicating that the ice box is not in position or has been
pulled out.
6. If the ice maker indicator shows red and is not flashing,
indicating that the ice maker is malfunctioning.
(FM4BM28IFBI Model only)
LED Light Replacement Instructions
Note: Only proceed with the LED light replacement if you
are confident in your abilities, otherwise please contact a
service technician to assist.
Lighting parameters: 12V / 10W
1. Unplug the power plug.
2. Remove the aluminum alloy trim strip on the top of the
LED surface light source, and then remove the left and right
fixing screws.
Steps 1 and 2 are shown below.
3. Replace the spare LED light board.
4. Replace the aluminum alloy trim strip in turn.
EN
9
Publicité
