HQ Power VDPDMXC144 Mode D'emploi page 2

• Familiarise yourself with the functions of the device before actually using it. Do not permit
operation by unqualified people. Any damage that may occur will probably be due to
unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• Note that all modifications of the device are forbidden for safety reasons.
• Do not remove the serial number sticker from the device as doing so will void the warranty.
Only use the device for its intended purpose. All other uses may cause short circuits, burns,
electroshocks, lamp explosions, crashes, etc. Using the device in an unauthorised way will
void the warranty.
4. Description
a) Front Panel
A. Scene display
B. Programme display
C. Projector display
D. Insert button
E. Delete button
F. Programme selection button
G. Projector selection button
H. Up button
I. Down button
J. Select button
K. Stand slider
L. Cross slider
M. 6 channel faders
b) Back Panel
1. Power switch
2. Input socket for DC adapter
3. DMX output socket (3-pin female XLR)
c) Connections
The manufacturer is not responsible for damage caused by improper connections.
Connect the supplied adapter with the DC jack and connect the other end with a mains outlet.
Plug the XLR cable into the VDPDMXC144 and connect the other end with the first device to be
controlled. Activate the device with the power switch.
You will hear a beep and the device will perform an initial check on all the displays. The device
is ready for use once this is finished.
VDPDMXC144
All manuals and user guides at all-guides.com
2
Fig. 1
Fig. 2
VELLEMAN