Using The Device - Tecno-gaz CLEAN Mode D'emploi Original

USING THE DEVICE
To use the device correctly start by pulling out the plastic cap (POS.A).
Fill the container in the circular ring about half way up (POS.B). Pour
the solvent on the brush (POS.C). Take the tools that need to be
cleaned and start brushing them, making coordinated circular up‐and‐
down movements and vice versa (pay attention to excessive splashes
of solvent when going up). At this stage, each cleaned tool can be
placed in the circular ring at the stand‐by stage.
After cleaning the tools you can proceed with the treatments below,
part of the sterilization cycle. Finish by emptying the device and start
the full cleaning stage (MAINTENANCE AND CLEANING section p.11)
Wear suitable protective clothing. Avoid contact and inhalation of vapors
of the solvent inside. Keep in a cool and dry place. Keep away from heat
sources and direct exposure to light. Make sure it is firmly closed after
using it.
C
A
B
9
ENGLISH
FIG. 2