Panasonic AJ-CA905G Mode D'emploi page 11

Setting the internal switch
CAUTION:
These servicing instructions are for use by qualified service personnel only. To reduce the risk of fire
or electric shock do not perform any servicing other than that contained in the operating instructions
unless you are qualified to do so.
Select the microphone to be used for INCOM (Inter-
Communication).
CM (carbon type) is the factory setting.
Dynamic type
DM
Carbon type
CM
Drip-proof rubber part
1
Side panel
Screws
2
Remove the four screws, and take off the side
panel.
<Notes>
O The screws cannot be removed from the side
panel.
O Take care not to disengage the drip-proof rubber
part used for the POWER switch.
O The side panel is connected to the main unit by
a cable. Do not pull it using excessive force.
Select the position of the switch on the back side of
the side panel.
11 (E)