Télécharger Imprimer la page

Tristar ST-8138 Mode D'emploi page 5

Masquer les pouces Voir aussi pour ST-8138:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
To remove stubborn wrinkles, you can press the spray button to bring
your ironing to moisten. Turn the spray button right to spray. For an
extra shot of steam, turn the spray button to the left and press the
spray button.
GARMENT LABEL
FABRIC TYPE
Synthetic
Silk - Wool
Cotton -
linen
Fabric not to be ironed
CLEANING YOUR IRON
Fill the reservoir with cold tap water.
Insert the plug into the wall outlet and set the thermostat on the MAX
setting.
Hold the iron above the sink.
Turn the steam switch to position 4 and press repeatedly to spray
button.
The steam holes are cleaned.
Turn the thermostat to the MIN-institution and turn the steam switch
to position 3.
Remove the pen from the iron and clean it with a cloth. Then place it
back into the iron.
Clean the iron with a soft damp cloth. Note the sole iron is hot!
You should remove all the water before you store the iron.
THERMOSTAT REGULATION
•Low temperature
••Med temperature
••MAX temperature
Attention! The iron is very hot do not touch
GUARANTEE
Tristar is not liable for damages occurred through:
o In case the appliance has fallen.
o In case the appliance has been technically changed by the owner or
another third party.
o In case of improper use of the appliance.
o In case of normal wear of the appliance.
By executing repairs the original warranty period of 2 years will not
be extended, nor the right to a complied new warranty. This warranty
is only legal on European soil. This warranty does not overrule the
European directive 1944/44CE.
Always keep your receipt, without this receipt you can not claim any
form of warranty whatsoever.
Damage caused by not following the instruction manual will lead to a
void of warranty, if this results in consequential damages Tristar will not
be liable.
Tristar will not be liable for material damage or personal injury caused
by improper use or if the safety instructions are not properly executed.
Cleaning, as mentioned in this manual, is the only necessary
maintenance for this appliance.
When the appliance should be repaired, make sure that this will be
performed by an authorized company.
This appliance may not be amended or changed.
If problems arise during the 2 years from the date of purchase, which
are covered by the factory warranty, you can go back to the point of
purchase to replace it for a new one.
For questions or compliances please contact your retailer "point of
purchase. "
Steam iron
EN
5

Publicité

loading