Setting Of Switching Points For The Air-Saving Function With [H-1] And [H-1] - schmalz SCPi Notice D'utilisation

Setting of switching points for the air-saving function with [H-1]
and [h-1]
The deactivation value
this function.
[H-1]
When the deactivation value is reached or exceeded, then the H1 LED is also
switched on.
The switching points of the air-saving function are set as follows:
 Press the
 Enter a valid PIN if the menu is locked.
 Select the desired
 Confirm by pressing the
 Change the value using the
 Press the
The display automatically jumps to the next setting value.

When the
changed is scrolled through quickly.

The value is not accepted when exited using the

The air-saving function is activated in the configuration menu with
deactivated with [ctr=off].
S
C H MA LZ
[H-1]
and hysteresis
button.
[H-1] [h-1]
or
button.
or
button to save the changed value.
or button is pressed for approx. 3 seconds, the value to be
SCP / SMP
I I
[h-1]
of the air-saving function are set using
parameter using the
buttons.
GB - 10
or buttons.
button.
[ctr=on]
and