Burkert 8137 Manuel D'instructions page 6

2 For your safety
6
All manuals and user guides at all-guides.com
During the entire duration of use, the user is obliged to determine the
compliance of the required occupational safety measures with the
current valid rules and regulations and also take note of new
regulations.
2.5 Safety approval markings and safety tips
The safety approval markings and safety tips on the device must be
observed.
2.6 CE conformity
The protection goals of the EMC Directive 2004/108/EC (EMC), the R
& TTE directive 1999/5/EC and the Low Voltage Directive 2006/95/EC
(LVD) are fulfilled.
Conformity has been judged according to the following standards:
EMC: EN 61326-1: 2006
(electrical instruments for control technology and laboratory use - EMC
requirements)
Emission: Class B
l
Susceptibility: Industrial areas
l
R & TTE
I-ETS 300-440 Expert opinion No. 0043052-02/SEE, Notified Body No.
0499
LVD: EN 61010-1: 2001
(safety regulations for electrical measurement, control and laboratory
instruments - part 1: General requirements)
2.7 Compatibility according to NAMUR NE 53
With regard to compatibility, the NAMUR recommendation NE 53 is
fulfilled. This applies also to the corresponding indicating and
adjustment components.
The parameter adjustment of the basic sensor functions is independ-
ent of the software version. The range of available functions depends
on the respective software version of the individual components.
The software version of LEVEL TRANSMITTER 8137 can be
determined as follows:
on the type label of the electronics
l
via the indicating and adjustment module
l
R & TTE-Richtlinie 1999/5/EC: Not with version with increased sensitivity.
1)
1)
LEVEL TRANSMITTER 8137 • 4 ... 20 mA/HART