28
PROGRAMMING THE MACHINE
MILK CIRCUIT WASH CYCLE
To rinse the machine's internal circuits used for preparing milk.
This cycle is proposed after 14 days from the fi rst dispensing of a milk-based beverage. After 14 days, the "milk
cleaning" message starts fl ashing (see page 13). Perform the wash cycle as described in this section.
Push the "milk cleaning" button and refer to the instructions below, at step 2. The machine switches to the status
described at point 7.
If the milk circuit wash cycle is not performed after 14 days, the dispensing of milk-based beverages will be still
possible for only 7 more days. After 7 days, the wash cycle must be performed because the dispensing of milk-based
beverages is disabled. (The machine still enables dispensing hot water and coffee).
To remind the user of this important operation, the message "milk cleaning -3" is shown on the display 3 days before
the deadline and is updated on subsequent days.
Before performing this function make sure that:
1. a large enough container is at hand.
2. the milk container has been adequately cleaned of all milk residue.
3. the water tank contains a suffi cient quantity of water.
THE WASH CYCLE CANNOT BE INTERRUPTED. A PERSON MUST BE PRESENT DURING THE OPERATION.
USE ONLY AND EXCLUSIVELY THE PROVIDED DETERGENT.
coffee
1
lock
cleaning
display
cycle
milk
maintenance
cleaning
cycle
milk circuit
descaling
rinsing
cycle
cycle
back to
go back
menu
Select the function by
pressing the "milk cleaning
cycle" button.
All manuals and user guides at all-guides.com
milk
show icon
my custom
explanation
cleaning
coffee
milk
show icon
my custom
cleaning
explanation
coffee
-3
2
Open the compartment and
remove the milk container.
program-
ming
menu
program-
ming
menu
3
Insert the content of the
detergent packet into the
container.